Shower Door Replacement In Bloomfield Hills
Leaking, foggy, rusted, or just dated. When a shower door has given all it has, Fortune removes the old enclosure and installs new custom glass in your Bloomfield Hills bath, usually without touching the tile.
When The Old Door Has Had Enough
Shower doors wear out in predictable ways. The seal at the bottom hardens and stops holding water back. The frame pits and streaks where hard water sat against it. The glass clouds because years of minerals have etched the surface, and no cleaner brings it back. Rollers drag, hinges sag, the door catches on the way closed. Or nothing is broken at all and the door is simply the last piece of a bath that was updated around it. In an estate home in Bloomfield Hills, a tired gold-framed enclosure can undo a beautifully finished room all by itself. Any of those is a good reason to call.
Fortune replaces shower doors. That is a different job from patching one, and we are honest about the line. We do not service or fix an existing enclosure. What we do is take out the old door, hardware, and frame, and set new custom glass in the same opening, so you keep the tile and the plumbing you already have. For most homeowners that is the whole appeal. A bath that looked dated can look current again once the new glass is in, without a contractor, a dumpster, or a month of dust. The glass is measured, built, and installed by the same family.
Shower Door Replacement, measured and built for Bloomfield Hills.
Keep Your Tile
A replacement works inside the opening you already have. The tile, the tub, and the plumbing stay where they are. We take out the old enclosure, measure what is left, and build glass that fits it. That is one of the simplest ways to make an older bath feel new again.
Etched Glass Stays Etched
Hard water in Oakland County leaves minerals behind, and over years they etch into the surface. Once glass is cloudy in that way, no cleaner and no amount of scrubbing will bring the clarity back. Replacing the panel is the fix, and easy-clean glass is worth asking about for the next one.
A Straight Answer First
At the free measure we look at the opening the old door leaves behind, including the anchor points and the sealant lines, and tell you what the space will accept. If a frameless panel is not realistic there, we will say so and show you what is. You decide from real information.
What A Replacement Actually Involves
It starts with a free in-home measure. We look at the door you have, the opening behind it, and the walls and curb it sits on. Old enclosures leave marks, and old anchors do not always land where new hardware wants to go, so we take honest readings and tell you what the space will support. Then you pick the style, the glass, and the finish. Nothing is ordered until you have seen a number and said yes. There is no fee and no pressure in that visit.
Then the same family fabricates your glass and comes back to install it. The old door and its hardware come out, the new glass goes in, and the joints are sealed. Because the panel was cut to your opening rather than pulled off a shelf, it lands where it should instead of being forced. A replacement is also the natural moment to move up a class, from a framed enclosure to semi-frameless or frameless glass, since the tile is already there and only the door is changing.
- Old enclosure removed
- Your tile stays put
- New glass cut to fit
- Fogged or etched glass replaced
- A full range of finishes
- Free measure and quote
Common questions.
Can you replace my shower door without redoing the tile?
In most cases, yes. A replacement works inside the opening you already have, so the tile, the tub, and the plumbing stay put. We remove the old door and hardware and set new glass in its place. If we see something at the measure that would make that a bad idea, we will tell you before you spend a dollar. The measure itself is free.
My glass is cloudy. Can it be cleaned or does it need replacing?
If your usual cleaner no longer touches it, the minerals have likely etched into the glass, and etching does not wash off. At that point replacement is the honest answer. New glass with an easy-clean coating gives you a fresh start and holds up better against Oakland County water than an untreated panel. We will look at yours during the free measure and tell you plainly.
Should I replace my shower door or try to fix it?
It depends on what has failed. When the glass is etched or clouded and will not come clean, or the frame has rust and the seals are worn out, a new custom enclosure usually gives a better and longer lasting result than patching the old one. Call the showroom at (586) 315-8900 or text us a photo of your door, and we will tell you honestly what we think makes sense for your bathroom.
Do you replace shower doors in Bloomfield Hills?
Yes. We serve Bloomfield Hills and the rest of Oakland County from our showroom at 42624 Van Dyke Ave in Sterling Heights. The same family measures your opening, fabricates the glass, and installs it, so nothing is handed to a subcontractor. Call (586) 315-8900 or text (586) 800-9481 to book the free measure. Hours are Mon to Fri 9-5 and Sat 10-2.
Can I switch styles when I replace the door?
Usually. A replacement is a good moment to rethink the enclosure, not just copy the old one. Whether the opening will take a heavier frameless panel depends on the walls, the curb, and what is behind the tile, so we check that during the measure. If it works, we will show you. If it does not, we will point you to what fits.
Time To Replace That Old Door?
Book a free, no-pressure in-home measure in Bloomfield Hills. Call (586) 315-8900 or text (586) 800-9481, and we will tell you honestly what your opening needs. Photos of the old door help.